Infusion tubing and accessories
PE infusion tube
PE tubing is primarily used in the resin infusion process to form the vacuum channel and the resin infusion network.
- Maximum temperature: 80°C
- Material: Polyethylene
- Length: 50 m
- Outer/inner diameter (mm):
- 10-8
- 12-10
- 11/14
- 16-13
- 21-18
Spiral infusion tube - SW
The SW spiral tube is primarily used in the resin infusion process.
Its main function is to distribute the resin over the infusion substrate.
- Maximum temperature: 80°C
- Material: Polyethylene
- Length: 50 m
- Outer/inner diameter (mm):
- 10-8
- 12-10
- 11/14
- 16-13
- 21-18
LINPLUG
The LINPLUG is a connector used in the infusion process to connect the resin tube to the spiral tube.
It reduces the risk of leaks and makes it easier to install the network.
There are two versions available:
- LINPLUG16 for connecting to the TUBE16-13 & SW16-13 tube
- LINPLUG12 for connecting to the TUBE12-10 & SW12-10
SPIROMESH - Vacuum Channel
A combination of a drainage net and a spiral sleeve.
This will allow you to optimize resin distribution on your part and prevent any marks on the laminate during the infusion process.
- Maximum temperature: 80°C
- Material: VI160W knitted drainage mesh + spiral sleeve
- Length: 50 m
- Size: 12 mm/16 mm
Infusion connectors
These connectors are primarily used in the resin infusion process to connect the tube to the spiral tube.
- Maximum temperature: 80°C
- Material: PE
- Diameter – 10 mm, 12 mm, and 16 mm
- Available in T-shaped, elbow, and straight versions
LAS600 Spray Adhesive
This is a high-quality product that bonds very quickly with a very thin layer.
It provides excellent adhesion to a wide variety of materials, including metals, plastics, foam materials, glass, and wood.
- Temperature resistance: 50–55°C
- Color: Pale yellow
LINCA & LINBOX - Infusion Rider
LINCA is a connector used in the infusion process to connect the resin tube to the spiral tube.
It reduces the risk of leaks and makes it easier to install the system.
Two versions are available:
- LINCA16 for connecting to Infusion TUBE16-13 & SW16-13
- LINCA12 for connecting to Infusion TUBE12-10 & SW12-10
Optionally, you can attach the LINBOX to the connectors to prevent creases in the vacuum film and improve stability on sloped surfaces.
PE Infusion Tap
Plastic valves are primarily used in the infusion process to open the resin supply line into the system.
- Maximum temperature: 80°C
- Material: PE
- Diameter – 10 mm, 12 mm, and 16 mm
- Compatible with TUBE12-10, TUBE14-11, and TUBE16-13 infusion tubing