Infusion Mesh
Infusion mesh helps to drain the resin alongside the part and spread it on all the surface between the vacuum lines.
It is highly recommanded to use this material during your infusion process.
There is 2 types of infusion mesh :
- Knitted media: Smooth 160g/m²
- Extruded media: Stiff from 200g/m² to 460g/m², depending on the resin viscosity flow similar to the knitted media.
VI160W - PE knitted - 160g/m² - 120°C - Up to 4m wide
High economical knitted infusion mesh.
It is compatible with most substrate including composite moulds and films.
The main application are with vacuum infusion operation at room temperature.
- Colour: White
- Maximum temperature: 120°C
- Width: Up to 4m
- Weight: 160 g/m²
VI200E - PE extruded - 200g/m² - 120°C - Up to 2m wide
High economical extruded infusion mesh, is compatible with most substrate including composite moulds and films, applies to vacuum infusion operation at room temperature.
- Colour: Green
- Maximum temperature: 120°C
- Width: Up to 2m
- Weight: 200 g/m²
VI250E - PE extruded - 250g/m² - 120°C - Up to 2m wide
High economical extruded infusion mesh, is compatible with most substrate including composite moulds and films, applies to vacuum infusion operation at room temperature.
- Colour: Green
- Maximum temperature: 120°C
- Width: Up to 2m
- Weight: 250 g/m²
VI460E - PE extruded - 460g/m² - 120°C - Up to 2m wide
High economical extruded infusion mesh, is compatible with most substrate including composite moulds and films, applies to vacuum infusion operation at room temperature.
- Colour: Blue
- Maximum temperature: 120°C
- Width: Up to 2m
- Weight: 460 g/m²